If the Navimow i2 LiDAR is used regularly, it is recommended to replace the blades and screws every 80 working hours to ensure safety and better mowing results. Wear heavy-duty gloves when you check or service the blade. Follow the steps below:
1. Press the OK button for 3 seconds to turn off the mower.
2. To avoid scratching, place the Navimow i2 LiDAR on a soft and clean surface in an upside-down position.
3. Use a cross-tip/Philips head screwdriver to loosen the three screws.
4. Remove the screws and blades.
5. Fasten the new blades and screws. Make sure the blades can pivot freely.
Comments
0 comments
Article is closed for comments.