Powering On:
You can power on the Navimow i2 LiDAR in two ways:
1. Connect the Navimow i2 LiDAR to the charging station while it is plugged into an active power outlet. The mower will power on automatically.
2. If the Navimow i2 LiDAR is not connected to the charging station and has sufficient battery, press and hold the OK button for 1 second to power it on.
Powering Off:
To power off the mower, first disconnect it from the charging station, then press and hold the OK button for 3 seconds.
NOTE: If the anti-theft feature is activated, you must enter the PIN code before the mower powers off.
You can power on the Navimow i2 LiDAR in two ways:
1. Connect the Navimow i2 LiDAR to the charging station while it is plugged into an active power outlet. The mower will power on automatically.
2. If the Navimow i2 LiDAR is not connected to the charging station and has sufficient battery, press and hold the OK button for 1 second to power it on.
Powering Off:
To power off the mower, first disconnect it from the charging station, then press and hold the OK button for 3 seconds.
NOTE: If the anti-theft feature is activated, you must enter the PIN code before the mower powers off.
Comments
0 comments
Article is closed for comments.